How To Repair A Dewalt Drill Dcd985

Drill chuck stuck? Information technology's fourth dimension to face up the fix. Whether y'all are a master carpenter or an occasional drill-seeker, eReplacementParts.com provides the parts, procedures and facts you need to fearlessly fix what fails yous.

The chuck could really be considered a normal-wearable item on any drill. Each time a drill bit slips (nether a high-torque state of affairs), it will habiliment the chuck a small corporeality. Eventually, the chuck will need to exist replaced. If the drill is often used in dirty or dusty conditions, it's non uncommon for the chuck to seize-up completely (or open and close with extreme difficulty). Replacing the chuck is very easy to practise.

This commodity provides step-past-step instructions for removing and installing the keyless chuck on a DeWALT cordless hammer drill.

Let'south get started. REMOVING THE CHUCK [meridian] one. Remove the battery.

Remove the bombardment from the drill.

2. Remove the chuck retaining screw.

Open up the chuck to the widest position.

Use a Torx commuter (size may vary) to loosen the retaining screw. This screw is REVERSE-THREADED (requiring CLOCKWISE rotation to loosen).

Remove the screw from the chuck assembly.

3. Switch the transmission to the lowest setting.

Slide the gear selector switch to the lowest setting.

4. Remove the chuck from the drill.

Insert the short end of a large Allen wrench (as large as the chuck volition conform) into the chuck assembly.

Secure the Allen wrench in the chuck.

Position the drill on a surface that allows the chuck (and Allen wrench) to overhang the border.

While deeply holding the drill against the work surface, strike the exposed stop of the Allen wrench with a hammer. This will (somewhen) loosen the chuck associates. (It may crave several attempts).

Keep to rotate (unscrew) the chuck assembly (past manus) until it disengages the spindle.

Remove the chuck assembly from the drill.

INSTALLING THE NEW CHUCK [superlative] v. Install the chuck.

Thread the new chuck assembly onto the spindle until information technology is hand-tight.

Open the chuck as wide equally possible.

Re-secure the Allen wrench in the chuck associates.

Utilize the Allen wrench to finish tightening the new chuck. (It is not necessary to strike the Allen wrench with a hammer).

Remove the Allen wrench from the chuck.

Install the retaining screw.

Secure the retaining screw with a Torx driver. The screw is Reverse-THREADED (requiring COUNTERCLOCKWISE rotation to secure).

REASSEMBLING THE Unit of measurement [top] vi. Reinstall the battery.

Install the battery.

Equally you lot just learned, fixing things yourself means more drilling with less billing. Hopefully, this article has restored your ability to drill holes without replacing your whole drill. And that's just the tip of the bit. Our online repair guides tin assist expand your skills far across drills; empowering you to face power tool issues whenever they ascend; and to fearlessly fix whatever fails you lot.

Detect your next set up here. [summit]

Source: https://www.ereplacementparts.com/repair-center/article/21161/How_to_Replace_the_Keyless_Chuck_on_a_DeWALT_Hammer_Drill.html

Posted by: brewerhistat.blogspot.com

Share this post